![]() I'm reprinting it with 220 nozzle and 70 bed, but still looks as if its lifting. Wost warping is between the two largest sections of the left wiing (only printed one side so far, when I put them together at the centre I have about 1mm gap on the leading edge and close to 5mm at the back. Thanks, I'm going to try to get mine flyable, will maybe try combination of sanding and filling if I can't get a warp free print. I wasn't planning on flying mine, I just wanted to see how the printer did on thin walls and those it did great. Still had some small gaps but I bet it would fly. I did sand the mating faces on a flat surface to straighten them and then glued them up. The little thin trailing edges on the widest of the wing sections were all I had trouble with, they would pull off the bed a mm or so. How did you get on with this, I'm getting lots of warping on the wing parts. Not much, I think I can sand the edges lightly and improve the fit. Came out looking pretty good, some of the really thin wing tips warped and raised up off the bed. 43 hours to print the whole plane on the mk3.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |